Top drawer cover panel A3: How to use on your Kangaroo and Joey, Christa or Sydney sewing cabinet

The attached video will go over how to install and remove the top drawer cover panel on your Kangaroo and Joey cabinet. 

Metal dowel pin installation: The threaded cam lock in the A3 panel may need to be turned using a phillipshead or small flat head screw driver to position the lock to receive the metal dowel pin. You'll then use a small flathead screw driver to screw the dowels into the edges of the A3 panel. 

Cam lock open to receive metal dowel pin:

If after assembly your top drawer cover panel does not sit down flat, you may need to move the magnet back slightly. You'll loosen, but not remove, the 2 screws holding the magnet. Once loosened you can push the magnet back and tighten the screws back down.

Magnet too far up:

Magnet pushed back: